Replacing HD Step 13 calls for Torx T6

Following your instructions for the removal/replacement of the HD

PowerBook G4 Aluminum 12" 1-1.5 GHz Hard Drive Replacement

at Step 13 it indicates that there are 2 hex screws. I have a Torx T6 driver but it just spins in those screws.

Any recommendations on how to get those screws out (and back in)?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

Chosen Solution

On the comments area beneath steps 9 to 16:

"I found that a T7 Torx screwdriver worked better for removing the two hex screws" slessard, Nov 7 2009 @ 2:33 PM

Was this answer helpful?

Score 0
Add a comment

Add your answer

kah will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 283