Skip to main content

Fix Your Stuff

Right to Repair

Store

Help

Original post by: mayer ,

Text:

'''The F01''' indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes. ... Be sure to unplug the washer before accessing internal components.

'''E03''' The overflow condition occurs if there is too much water or foam in the washer. If overflow occurs, the valves are closed and the drain pump switches on for at least 30 seconds. ... Once the error code is displayed, the cycle is terminated and all water is pumped out.

Unplug the machine for five minutes to allow it to reset the plug it back in and observe any results and report them back.

Status:

open