Skip to main content

Fix Your Stuff

Right to Repair

Store

Help

Original post by: oldturkey03 ,

Text:

Mariah Sklaney check at the front of the intake manifold

[image|1222163]

3.7L

The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold (Fig.18). An o-ring is used to seal the sensor to the intake manifold (Fig. 19).

(1) Disconnect electrical connector at sensor.

(2) Clean area around MAP sensor.

(3) Remove 2 sensor mounting screws.

(4) Remove MAP sensor from intake manifold.

(5) Check condition of sensor o-ring (Fig. 19).

[image|1222173]

INSTALLATION

The Manifold Absolute Pressure (MAP) sensor is mounted into the front of the intake manifold (Fig. 18). An o-ring is used to seal the sensor to the intake manifold (Fig. 19).

(1) Clean MAP sensor mounting hole at intake manifold.

(2) Check MAP sensor o-ring seal for cuts or tears.

(3) Position sensor into manifold.

(4) Install MAP sensor mounting bolts (screws). Tighten screws to 3 N·m (25 in. lbs.) torque.

(5) Connect electrical connector.

Status:

open