Skip to main content
Help

Original post by: Jimfixer ,

Text:

Clean them with IP alcohol . I'm assuming you used something like WD40 or some other light penetrating oil. If so you may have contaminated the contact with particulates that will be noticeable when it dries. To see what i mean spray some WD40 on a metal surface and come back to it when its dried . There will be a white film. In most cases where you use WD40 on electrical connections to help dry them out this wouldn't be an issue but in something as fine as this and as many pins as your LCD connector it probably is . Hope this helps . Nice to see you back , its been a while

Status:

open