⟐ Commented June 10, 2026 at 7:16 MST

1.     When I print a document with more than one page using the 2-sided print feature it prints on two sides, but the second side prints upside down.  I’ve checked all the printer properties and can see nothing untoward.

2.     When I launch Brother Utilities, and click on the Status Monitor icon nothing happens

⟐ Answered June 10, 2026 at 6:13 MST

⟐ Commented June 10, 2026 at 5:38 MST

Translation Romanian - English

the car starts, works, but does not exceed the speed of 70-80 Km

⟐ Answered June 10, 2026 at 5:36 MST

However, after reconnecting the charger, the charging indicator LED did not light up. I removed and reinstalled the BIOS chip several times, but the laptop still does not power on. When I press the power button, a red LED lights up briefly, and as soon as I release the button, it turns off. That is the only thing the laptop does.

One important note: when I removed the BIOS chip, I forgot to disconnect the CMOS/BIOS battery. I only disconnected the main laptop battery. However, I removed the chip carefully and did not short any pins or make contact with anything accidentally.

I also tried flashing another BIOS dump, including the original BIOS backup with the old password still present, but the laptop behaves exactly the same way.

Could anyone help me diagnose this issue?

⟐ Answer accepted June 10, 2026 at 4:16 MST

⟐ Answered June 10, 2026 at 3:51 MST

Questions:

1. Does the 01764D have the same connector layout and pin count as the 01681F, or are there wiring differences?
2. Does the 7kg-vs-9kg difference actually affect water level, spin, or calibration in practice — or does the firmware just run fine?
3. Has anyone actually fitted a 01764D into a 7kg WA70H-series machine? What was the result?
4. If water levels or spin are off after fitting, can the board be recalibrated — and how?

Recently, I've decided to pick up my New 3DS to play some Picross, and noticed that it wouldn't power on. I tried charging it over night, but it still wouldn't work, I assume it never charged despite turning on the charge light.

I checked with a multimeter and the battery only showed 1.2v, so I'll assume it's dead dead.

As I've been waiting for a new battery to arrive, I've been playing it with a power bank attached.

Today, it arrived, and the 3DS doesn't turn on with it. It sees the battery, it shows it's fully charged, but when I unplug the power bank, it immediately shuts off.

I don't want to assume I have a new dead battery just yet, but I haven't opened it just yet.

Pertaining to the USB-C mod, it's only become an issue now, despite around a year of using it, it charged the battery just fine.

Edit: Here is a picture of my board and mod. It's not the best, but I'll get a better one when I can

Edit 2: I think I have found the issue... Those cables aren't meant to be crimped, are they?...

Edit 3: I have tested what I presume to be both F1 and F2 fuses (it's the ones surrounded) and they appear, at first glance, to be nominal. There's a slight voltage drop in the F2 fuse (from 4.3 to 3.7 volts), but not being sure about nominal voltages, I'm assuming they're fine.

⟐ Answer accepted June 10, 2026 at 3:04 MST