Questions
-
Not charging, indicator green light
Hi, I have a Macbook Air 11" late 2010 which I recently replaced the topcase/keyboard due to a liquid spill. It was charging ...
Answers
-
Answer to: Are pentalobe screws still good after removed?
Check if the new back cover is seated properly. Screw should go back in provided that its head is not damaged when you removed it. Use the correct screw driver to remove screws. -
Answer to: Why won't my mac power on?
Try to do a PRAM reset. Follow the steps on this link. -
Answer to: MBP powers on, no sleep light or display.
Green means the charging mode is off and could mean two things, a fully charged battery or a bad logic board. Fans running in full speed is also a result when the battery is removed. How is the health of the battery? Try to download coconut battery to test it. Also, do a SMC reset following the steps on this link. -
Answer to: Swap the original A1151 logic board by a A1261 model?
The link says that logic boards on these models are compatible with each other even the parts. I wonder if the connectors are the same. -
Answer to: Size of logic board in a1151 and a1229 identical?
Then try this one. It says compatible on MacBook Pro 17" Models A1151 A1212 A1229 and A1261 -
Answer to: after disassembling my mbp，bluetooth and camera stop working
Which model of Macbook Pro do you have? -
Answer to: MacBook is completely dead.
Recheck if all the parts are properly reconnected. e.g. battery, ram... -
Answer to: Hard Drive not detected!
Hi, try to go to the BIOS settings and check what is the SATA settings. If it is in AHCI try to change it to ATA and vice versa if it is set to ATA and then save the settings before exit. You will have to change the Cache Module to OFF before you can change to ATA. -
Answer to: Please help identify a component on the logic board.
Hi, I can't really figure out which part you mean as you have not labeled it on the picture. But this picture might help you identify what you are looking for. -
Answer to: iSight camera light always on
Try to unplug the magsafe and take out the battery, hold down the power button for 10 seconds, then replace the battery and power it back on.
Page 1 of 2
Internal Speaker does not show on output sound device.