Teardowns I've Worked On
My Favorite Guides
Questions
-
I Separated the LCD from the digitizer!
I Finally did it after experimenting for months with broken screen assemblies that i had from repairing many iphones. The LCD... -
installing new digitizer HELP
im having a hard time as to what i do with the digitizer ribbon cable in the bottom left corner it seems to long to close wit... -
Can I use without a service plan?
i just got a verizon iphone 4 but i dont have verizon is there a way to use the phone just as an ipod? -
How do I tell if lcd is broken?
i removed a broken digitizer on my still working ipad 2 and once i had it off i tryed turning it on and the lcd stays black h... -
wont power on after removing digitizer?
I removed a smashed digitizer on a working ipad 2 and before i did it i made sure to power it off but now it wont turn on now... -
Flash not working after screen replacement
I replaced the screen assembly and now the flash doesnt work when you turn it on it will blink once but not turn on?? -
Would a GSM screen work on a CDMA model?
I noticed the only difference is the outer part of the screen where the screws go. The connectors are the same would it work? -
Shuts off when unplugged instantly
my iphone 4 will turn on when plugged in but shuts off the second i unplug it. Ive changed the battery and it does the same t... -
Results of screen replacement
After i successfully replaced the screen now my speaker sounds messed up it works but sounds muffled also i was wondering if ...
Page 1 of 9
Answers
-
Answer to: Apple Store Warranty Question?
Sorry Mayer your wrong because they didnt catch me!! HaHaHaHaHa -
Answer to: Battery Connector Broke off?
I guess im better than you at this stuff then because i replaced mine and now its working 100% again :) -
Answer to: Not charging after replacing battery connector?
nvm bad battery i guess swapped it out and now its charging fine -
Answer to: Help with replacing 109B chip
Can anyone help me out! -
Answer to: Wont Power on When Plugged In?
What are these two chips for because i didnt get anything with the multimeter so i removed them and im currently trying to solder replacements from a junk board.
Why am I getting temperature error?