Completed Guides

Notes

  • iBook G3 12" Top Shield Replacement

    Quote from neato:

    If your iBook is like mine (700MHz) The yellow screw was attached from the bottom through the bottom case and had to be removed earlier in order to remove the bottom case. Also the the green screw pictured to the left was missing already removed.

    It's the same to iBook G3 600 MHz

  • iBook G3 12" Upper Case Replacement

    Quote from Rolf Hug:

    The two red screws and the orange screw have to be removed (iBook G3 600 MHz).

    As well the yellow screw has to be removed according to description

  • iBook G3 12" Upper Case Replacement

    It's quite hard to get to the screw and loosen it.

  • iBook G3 12" Upper Case Replacement

    Quote from commenter:

    This photo is a little confusing. The shield should be off, which would show the correct positions of the yellow and orange screws. (The orange circle is in the wrong place.) Furthermore, these screws don't need to be removed at this stage (they hold the logic board to the frame). And finally, on my 800 MHz machine, BOTH these screws are 6 mm in length.

    The two red screws and the orange screw have to be removed (iBook G3 600 MHz).

  • iBook G3 12" DC-In Board Replacement

    Quote from Rolf Hug:

    picture of step 24 is confusing; go to page 9

    step 27 followings

  • iBook G3 12" DC-In Board Replacement

    picture of step 24 is confusing; go to page 9

  • iBook G3 12" Bottom Shield Replacement

    Quote from commenter:

    Upper left screw is 4.5 mm and has smaller head. The other four are 6 mm.

    All of the five screws are the same 6 mm in length (iBook G3 600 MHz)