This is the first time i’m doing this, but i’m gonna need to replace the back cover of my HP pavillion. This is mostly due to a crack that started forming a few months ago and i’m scared the screen might pop off. Is there a guide avalible to help me? I’m also not really sure over tools, so if anyone could give any suggestions, i’ll take them gladly.

For specifications, this is the specific model: HP Pavillion x360 Convertible 15-cr0xx.

Thank you for your time.

Edit: I wasn’t so specific in my question, so i’ll add some extra details. The part that needs replacing is the back of the LCD screen. Also. this is the best image i can find of the damage

Hallo zusammen

Habe bei einem Duplexdruck vergessen, den Stoff, der oben auf dem Drucker lag abzunehmen. Darum gabs Papierstau.

Ich habe schon oft Papierstau entfernt. Diesmal hat es nicht geklappt.

Ich kann das Papier sehen, wenn ich die hintere Klappe öffne. Ich konnte auch Teile davon rausziehen, manches mit Pinzette. Dabei habe ich bereits ein kleines orangefarbenes weiches Stück von einer Rolle erwischt. Das Papier klemmt zu weit Innen fest, hinter den weissen Rollen.

Um meinen Drucker nicht weiter zu verletzen, möchte ich ihn nun so weit auseinander nehmen, dass ich das Papier entfernen kann.

Und danach möchte ich ihn wieder zusammen gesetzt bekommen.

Gibts dazu eine Anleitung? Das wäre Klasse!

Gruss, Barbara

Hi,

I’m wondering if anyone can help. We have an LG 55UH850V. The tv has a problem where the screen goes black and the sounds stays on, when looking at with a torch you can see an image. I have replaced the edge lit backlight and changed the power board but still have the same issue. Can anyone point me in the direction of what to try next? Could it be I’ve installed a faulty backlight? The metal strip at the bottom of the tv (where the backlight is) seems to get really hot. Should a backlight be hot? Could the main board also cause this issue?

Thanks in advance for any replies.

=== ===

In short, what do i need to re-solder the battery door latch switch?

A few days ago my canon 60d suddenly stopped working, it turned on once after i waited a while but the screen glitched out and it died and wouldn’t turn on since then. I was filming in the heat on the beach constantly in the sun. I was trying to find a fix for my dead camera and some people said i should push the tiny switch that is under the battery door so i did, i tried that a few times, no luck with switching on the camera and i was thinking i’m doing something wrong and then tried it again and it went to one side and then broke off.

Now i disassembled it and found the switch, so now i want to solder it back in the right place and i want to know what tools do i need (Heat gun, solder with a tiny tip) or some kind of paste.

P.S. If you know, please tell me the reason why my camera suddenly died. Could it have been from overheating, because i didn’t turn it off, it was in the sun and the battery was empty.

The Switch:

The spot where it was: