first image
thumb image 1
thumb image 2
thumb image 3

Add Note Edit Step 10 — Hard Drive Replacement  ¶ 

  • Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.

  • When plugging the thermal sensor connector back into the hard drive, be sure it is inserted onto the set of pins closest to the SATA connectors and that the black wire of that connector is closest to the LCD.

first image

Add Note Edit Step 11  ¶ 

  • Remove the two T10 Torx screws securing the upper hard drive bracket to the outer case.

first image
thumb image 1
thumb image 2

Add Note Edit Step 12  ¶ 

  • Slightly rotate the hard drive away from the outer case.

  • Lift the hard drive off its two lower positioning pins and remove it from the outer case.

Next » « Previous

Comments Add Note Comments are offturn on