Changes to revision 135380:

Edit by Jonathan Wiesel:

Deleted
Added
Unchanged

Changes to text

[* black] Remove the following five screws securing the wi-fi antenna to to the logic board:
[* red] One 2.3 mm Phillips
[* orange] Two 1.6 mm Phillips
[* yellow] One 1.4 mm Phillips
[* green] One 4.8 mm Phillips
[* icon_caution] When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless.
[* icon_caution] Also make tosure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the wi-fi antenna and is often the culprit of you are having bad wi-fi reception after reassembly.
[* icon_caution] Also make tosure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the wi-fi antenna and is often the culprit of you are having bad wi-fi reception after reassembly.