Fix Your Stuff Community Store

Shark AI Ultra AV2511AE Drive Wheel Motor Replacement

Introduction

This is the Shark AI Ultra AV2511AE guide for the replacement of the drive wheel motors. The motors ensure the movement of this robot's vacuum main wheels. The motor must be replaced if the robot vacuum is not moving or is pivoting to one side.

What you need

  1. Shark AI Ultra AV2511AE Drive Wheel Motor Replacement, Drive Wheel Motor: step 1, image 1 of 2 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement, Drive Wheel Motor: step 1, image 2 of 2

    • Put the device with the wheel side up.

    • Remove the five 11 mm screws surrounding the drive wheel using a Torx TR15 screwdriver.

    • Gently pull the wheel assembly out.

    • Make sure to pull lightly on the wheel assembly to ensure wires do not rip apart.

    Edit

  2. Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 2, image 1 of 2 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 2, image 2 of 2

    • Separate the wire connector from the wheel assembly using an opening tool.

    Edit

  4. Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 3, image 1 of 2 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 3, image 2 of 2

    • Remove the spring from the wheel assembly.

    Edit

  5. Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 4, image 1 of 2 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 4, image 2 of 2

    • Remove the four 7 mm screws around the gearbox using a Torx TR8 screwdriver.

    • Remove the gearbox cover.

    • Be careful about handling the wheel assembly with the gearbox exposed. Debris can enter in and the gears may fall out.

    Edit

  6. Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 5, image 1 of 3 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 5, image 2 of 3 Shark AI Ultra AV2511AE Drive Wheel Motor Replacement: step 5, image 3 of 3

    • If holding the motor vertical, it may fall out once the screws are removed.

    • Using the Phillips #0 screwdriver, remove the two 4mm screws holding the motor to the gearbox.

    • Remove the motor.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 3 other contributors

Brycen Wirick

Member since: 09/20/23

271 Reputation

1 Guide authored

Badges: 6

+3 more badges

Team

Utah Tech University, Team 1-3, McMurrin Fall 2023 Member of Utah Tech University, Team 1-3, McMurrin Fall 2023

UTAHTECH-MCMURRIN-F23S1G3

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 4

Past 30 Days: 24

All Time: 221