first image

Add Note Edit Step 7 — Logic Board  ¶ 

  • With the rear case removed, the back side of your Nano should now look like this.

first image

Add Note Edit Step 8  ¶ 

  • Remove the following six screws:

    • One 1.8 mm Phillips.

    • Three 1.9 mm Phillips.

    • One 2.4 mm Phillips.

    • One 2.6 mm Phillips.

first image
thumb image 1
thumb image 2

Add Note Edit Step 9  ¶ 

  • Using a spudger, flip up the brown click wheel ribbon cable retaining clip.

  • The clip is hinged at the end nearest the edge of the case.

Next » « Previous

Comments Add Note Comments are offturn on