View profile
Logout
« Previous
Next »
Page 3 of 6
With the rear case removed, the back side of your Nano should now look like this.
Remove the following six screws:
One 1.8 mm Phillips.
Three 1.9 mm Phillips.
One 2.4 mm Phillips.
One 2.6 mm Phillips.
Using a spudger, flip up the brown click wheel ribbon cable retaining clip.
The clip is hinged at the end nearest the edge of the case.
Next » « Previous
$2.95 · 50+ in stock
$4.95 · 50+ in stock
$29.95
$24.95 · 50+ in stock
$7.95 · 50+ in stock
$59.95 · 50+ in stock
$6.95 · 50+ in stock
1024
Notes are offturn on