Installing iPod 3rd Generation Rear Panel

Add Note Introduction

The shiny rear half or your iPod case.

Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Case

  • Before opening your iPod, ensure that the hold switch is in the locked position. The orange bar should be visible, indicating hold is active.

first image
thumb image 1
thumb image 2

Add Note Step 2

  • Opening the case can be challenging. Do not get discouraged if it takes you a few tries before the iPod is opened.

  • Insert a large iPod opening tool into the seam between the plastic front and metal rear panel of the iPod, near the headphone jack. The tool's edge should point toward the metal rear panel to prevent any accidental scratching of the plastic front.

  • Run the tool along the top seam toward the upper left corner of the iPod.

first image

Add Note Step 3

  • Push the large iPod opening tool into the upper left corner of the iPod, creating a small gap along the side seam.

Add NoteNotes: Step 2

andylieberman's avatar
Flag Reply by andylieberman Jun 6 @ 3:59 PM

You want to push the tool against the top of the iPod case. The top will flex inward just enough so that you can push the edge of the tool down and run it along the seam