Installing iPod 2nd Generation Touch Wheel

Add Note Introduction

The touch wheel receives the feedback of your fingers and transmits it to the logic board.

Tools used in this guide
Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Rear Panel

  • Before opening your iPod, ensure that the hold switch is in the locked position.

first image

Add Note Step 2

  • Opening the iPod can be challenging. Don't get discouraged if it takes a few tries before the iPod is opened.

  • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

first image

Add Note Step 3

  • Continue to run the opening tool along the side of the case until all five tabs have been released.

Notes

There are no notes