Installing iPhone 3G Dock Connector

Add Note Introduction

Connects the iPhone to a computer or charger via a iPhone cable.

Paginated Single Page Steps

first image

Add Note Step 1 — Dock Connector

  • Remove the two Phillips #00 screws from the dock-connector end of the iPhone.

first image

Add Note Step 2

  • There is a rubber gasket between the silver front bezel and black display assembly. A bit of force is required in this step to separate the iPhone's display assembly.

  • Use a small suction cup near the Home button to gently pull up the bottom portion of the iPhone's display assembly.

first image

Add Note Step 3

  • The display assembly is still connected to the iPhone by several cables, so don't try to remove it entirely just yet.

  • Rotate the display assembly up until it is at an angle of approximately 45 degrees.

Notes

There are no notes