first image
thumb image 1
thumb image 2

Add Note Edit Step 10  ¶ 

  • Use a spudger to disconnect the ribbon cable labeled "6."

  • If you have an iPhone 3GS, refer to the second picture and use a spudger to disconnect the ribbon cable labeled "7."

first image

Add Note Edit Step 11  ¶ 

  • Carefully peel up the small sticker labeled "Do not remove."

first image

Add Note Edit Step 12  ¶ 

  • Remove the following 8 screws:

    • Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear panel.

    • Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

    • One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

  • Note for re-assembly:

    • The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

    • Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera

Next » « Previous

Required Tools

Spudger

$2.95 · 50+ in stock

Phillips #00 Screwdriver

$4.95 · 50+ in stock

Small Suction Cup

$2.95 · 50+ in stock

SIM Card Eject Tool

$2.95 · 50+ in stock

Related Products

iPhone 3G Replacement Battery

$14.95 · 50+ in stock

Recommended Tools

Home Tech Toolkit

$24.95 · 50+ in stock

Sorting Tray

$7.95 · 50+ in stock

Anti-Static Wrist Strap

$7.95 · 13 in stock

Pro Tech Base Toolkit

$59.95 · 50+ in stock

Thirsty Bag

$6.95 · 50+ in stock

Notes Add Note Notes are offturn on