first image

Add Note Edit Step 22  ¶ 

  • Remove the following 3 screws on the edges of the keyboard area:

    • Two 6 mm Phillips underneath the keyboard area.

    • One 9 mm Phillips above the keyboard area.

  • On some models, there may also be a screw under the magnet you just removed. If so, remove the screw at this point.

first image

Add Note Edit Step 23  ¶ 

  • This is a diagram of the ribbon clamp connectors you will disconnect in the next step.

  • With your fingernails, grasp the locking bar on either side and pull up a small amount (about 1/16" or 2 mm).

  • After disengaging the locking bar, slide the cable out of the connector.

first image

Add Note Edit Step 24  ¶ 

  • Loosen the trackpad connector by pulling the top piece up slightly, freeing the trackpad ribbon.

  • Slide the orange trackpad ribbon out of the connector.

Next » « Previous

Required Tools

T8 Torx Security Bit Screwdriver

$6.95 · 48 in stock

Anti-Static Wrist Strap

$7.95 · 13 in stock

Spudger

$2.95 · 50+ in stock

Phillips #00 Screwdriver

$4.95 · 50+ in stock

Flathead 3/32" or 2.5 mm Screwdriver

$4.95 · 50+ in stock

Related Products

iBook G3 14" 800 MHz Logic Board

$299.95

Recommended Tools

Home Tech Toolkit

$24.95 · 50+ in stock

Sorting Tray

$7.95 · 50+ in stock

Anti-Static Wrist Strap

$7.95 · 13 in stock

Pro Tech Base Toolkit

$59.95 · 50+ in stock

Thirsty Bag

$6.95 · 50+ in stock

Notes Add Note Notes are offturn on