first image

Add Note Step 67 — Logic Board

  • Your laptop should look approximately like this.

first image

Add Note Step 68

  • Remove the three Phillips securing the heat sink to the metal framework.

  • Remove the rear plastic grill and IO Bezel.

first image

Add Note Step 69

  • Turn the remains of the computer over.

  • Remove the following 6 screws:

    • One 4 mm Phillips at the upper right corner of the logic board.

    • One 6 mm Phillips at the front of the computer, near the sleep light.

    • Two 6 mm small-head Philips from the middle of the logic board

    • Two 7.5 mm small-head Phillips, one on either side of the battery contacts.

Add NoteNotes: Step 69

commenter's avatar
Flag Reply by commenter Oct 13 @ 4:02 PM

If you have been following along, the 6 mm (orange) screw here would have already been removed in step 24, where its position is not quite correct, and it is incorrectly labeled as a "4.5 mm" screw.