Installing iBook G3 12" IO Bezel

Add Note Introduction

Replacing the plastic covering surrounding the input and output ports.

Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Battery

  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

first image

Add Note Step 2 — Keyboard

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

first image

Add Note Step 3

  • If the computer does not an Airport card installed, skip the next two steps.

  • Push the wire clasp toward the Airport card and pull it up to free it from the RAM shield.

Notes

There are no notes