Many of iFixit's interactive features require Javascript. We recommend that you activate Javascript or use a different browser.
Many of iFixit's interactive features require cookies. We recommend that you activate cookies or use a different browser.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
$14.95 · 19 in stock
$2.95 · 896 in stock
$4.95 · 73 in stock
$4.95 · 468 in stock
$4.95 · 65 in stock
Upgrade or replace the combo or...
135 recent views
The vibrating part of the iPhone.
83 recent views
You can install hard drives up...
60 recent views
Instructions on how to remove...
105 recent views
« Previous
Next »
Page 2 of 6
Remove the three newly-revealed Phillips screws.
Use a spudger or small flathead screwdriver to pry up the three metal rings that housed the rubber bumpers.
Remove the three hex screws using a T8 Torx screwdriver.
FYI, the two screws at the top of this picture are longer than the one in the middle of the case. Don't mix them up!
[quote|JuciusMaximus]FYI, the two screws at the top of this picture are longer than the one in the middle of the case. Don't mix them up![/quote]
Top screws are 20 mm, middle one is 10 mm. These have thread lock.
[quote|commenter]Top screws are 20 mm, middle one is 10 mm. These have thread lock.[/quote]
FYI, the two screws at the top of this picture are longer than the one in the middle of the case. Don't mix them up!
Top screws are 20 mm, middle one is 10 mm. These have thread lock.