Installing PowerBook G4 Titanium Onyx RAM

  • Author: iRobot
  • Difficulty: Easy
  • Add Note x
  • x 3

Two RAM slots allow up to 1 GB of PC133 RAM.

Sections
Files
Relevant parts
first image

Add Note Edit Step 1 — Keyboard  ¶ 

  • Remove the battery.

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

first image

Add Note Edit Step 2  ¶ 

  • Rest the keyboard face down on the trackpad area.

  • Disconnect the keyboard connector from the logic board.

first image

Add Note Edit Step 3  ¶ 

  • Your laptop should look approximately like this.

first image

Add Note Edit Step 4 — RAM  ¶ 

  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to ÒpopÓ up.

  • Pull the RAM chip out.

  • Repeat this process if a second RAM chip is installed.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G4 Titanium Onyx device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on