Installing PowerBook G4 Titanium Mercury Keyboard

Add Note Introduction

Replacing this keyboard is easy. It requires no tools, and takes only a few minutes.

Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Keyboard

  • Remove the battery.

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

first image

Add Note Step 2

  • Rest the keyboard face down on the trackpad area.

  • Disconnect the keyboard connector from the logic board.

first image

Add Note Step 3

  • Your laptop should look approximately like this.

Congratulations!

Share your repair story!

  

To reassemble your device, follow these instructions in reverse order. For more information, check out the PowerBook G4 Titanium Mercury device page.

Did you successfully follow this guide?

Notes

There are no notes