Installing PowerBook G4 Titanium Mercury Display

Add Note Introduction

Change out the entire display assembly, including the hinges and casing. This installation is MUCH easier than replacing just the LCD panel.

Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Keyboard

  • Remove the battery.

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

first image

Add Note Step 2

  • Rest the keyboard face down on the trackpad area.

  • Disconnect the keyboard connector from the logic board.

first image

Add Note Step 3

  • Your laptop should look approximately like this.

Notes

There are no notes