Installing PowerBook G4 Titanium DVI Lower Case

  • Author: iRobot
  • Difficulty: Moderate
  • Add Note x

The bottom case slides off easily after removing a few T8 Torx screws.

Sections
Files
Tools
Relevant parts
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Battery  ¶ 

  • Locate the battery release tab on the underside of the G4.

  • Slide the battery release tab to the left and lift the battery out of the computer.

first image

Add Note Edit Step 2 — Lower Case  ¶ 

  • Remove the seven T8 Torx screws from the lower case.

first image

Add Note Edit Step 3  ¶ 

  • Using your thumbs, slide the lower case away from you.

  • The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

  • Lift the lower case off.

first image

Add Note Edit Step 4  ¶ 

  • Your laptop should look approximately like this.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G4 Titanium DVI device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on