Installing PowerBook G4 Titanium DVI Hard Drive

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Author: iRobot
  • Difficulty: Moderate
  • Add Note x
  • x 10

How to remove the hard drive, along with its cable and bracket from your computer.

Sections
Files
Tools
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Battery  ¶ 

  • Locate the battery release tab on the underside of the G4.

  • Slide the battery release tab to the left and lift the battery out of the computer.

first image

Add Note Edit Step 2 — Lower Case  ¶ 

  • Remove the seven T8 Torx screws from the lower case.

first image

Add Note Edit Step 3  ¶ 

  • Using your thumbs, slide the lower case away from you.

  • The lower case may stick in the front on a tab just above the center of the optical drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive.

  • Lift the lower case off.

first image

Add Note Edit Step 4  ¶ 

  • Your laptop should look approximately like this.

first image

Add Note Edit Step 5 — Hard Drive  ¶ 

  • Disconnect the hard drive ribbon from the logic board using a spudger or the tip of your finger.

first image

Add Note Edit Step 6  ¶ 

  • To free the hard drive, remove the two T8 Torx screws from the right wall of the battery housing.

first image

Add Note Edit Step 7  ¶ 

  • Remove the hard drive by lifting the left edge up and out of the computer.

  • There are four rubber bumpers that fit over the hard drive screws. Ensure that these bumpers come out when you remove the hard drive.

first image

Add Note Edit Step 8  ¶ 

  • Your laptop should look approximately like this.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G4 Titanium DVI device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on