Installing PowerBook G4 Aluminum 12" 867 MHz RAM

Add Note Introduction

One RAM slot will accept PC2100 or PC2700 chips up to 1 GB.

Tools used in this guide
Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Battery

  • Use a coin to turn the battery locking screw 90 degrees to the right.

  • Lift the battery out of the computer.

first image

Add Note Step 2 — RAM

  • Remove the four Phillips screws from the memory door.

  • Slide the memory door away from the memory compartment.

first image

Add Note Step 3

  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  • Pull the chip directly out from its connectors.

Congratulations!

Share your repair story!

  

To reassemble your device, follow these instructions in reverse order. For more information, check out the PowerBook G4 Aluminum 12" 867 MHz device page.

Did you successfully follow this guide?

Notes

There are no notes