Installing PowerBook G4 Aluminum 12" 867 MHz DC-to-DC Board

Add Note Introduction

The DC-to-DC board connects the battery to the computer.

Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Battery

  • Use a coin to turn the battery locking screw 90 degrees to the right.

  • Lift the battery out of the computer.

first image

Add Note Step 2 — EMI Finger

  • Remove the four Phillips screws from the memory door.

  • Slide the memory door away from the memory compartment.

first image

Add Note Step 3

  • Remove the long black Phillips screw next to the memory card.

  • Remove the small EMI finger beneath the black screw.

Notes

There are no notes