Installing PowerBook G3 Pismo Heat Shield

  • Author: iRobot
  • Difficulty: Easy
  • Add Note x

Removing the heat shield enables access to the RAM and the processor below.

Sections
Files
Tools
Relevant parts
first image

Add Note Edit Step 1 — Keyboard  ¶ 

  • Turn the keyboard locking screw so that it is parallel to the space bar.

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • Lift the keyboard out by pulling it up and away from you. Rest the keyboard, face down, on top of the track pad.

first image

Add Note Edit Step 2  ¶ 

  • Pull the keyboard ribbon straight up from the logic board. Place the keyboard aside.

  • The connector may be tight. Gently rock the connector from side to side while pulling directly upward to free it. You can use this technique on many of the cards and cables you'll be disconnecting.

  • Make sure you have removed the laptop battery and CD/DVD modules from the expansion bays before proceeding.

first image

Add Note Edit Step 3  ¶ 

  • Your laptop should look approximately like this.

first image

Add Note Edit Step 4 — Heat Shield  ¶ 

  • Remove the two silver Phillips #1 screws that attach the heat shield to the internal metal framework.

  • Lift the heat shield up and pull it toward you.

first image

Add Note Edit Step 5  ¶ 

  • Your laptop should look approximately like this.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G3 Pismo device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on