Installing PowerBook G3 Lombard Heat Shield

  • Author: iRobot
  • Difficulty: Easy
  • Add Note x

Removing the heat shield enables access to the RAM and the processor below.

Sections
Files
Tools
Relevant parts
first image

Add Note Edit Step 1 — Keyboard  ¶ 

  • Turn the computer so that the ports are facing you.

  • If the keyboard is locked, open the port cover and turn the keyboard locking screw until the keyboard is unlocked.

first image

Add Note Edit Step 2  ¶ 

  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

  • Make sure you have removed the laptop battery and CD/DVD module from the expansion bays before proceeding.

first image

Add Note Edit Step 3  ¶ 

  • Lift the keyboard out by pulling it up and away from you. Rest the keyboard, face down, on top of the trackpad.

  • In order to replace the keyboard, you must first remove the modem.

first image

Add Note Edit Step 4 — Heat Shield  ¶ 

  • Remove the three silver Phillips screws that attach the heat shield to the internal metal framework.

first image

Add Note Edit Step 5  ¶ 

  • Lift the heat shield up and pull it toward you.

first image

Add Note Edit Step 6  ¶ 

  • Your laptop should look approximately like this.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G3 Lombard device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on