Introduction
Replacing the hard drive on a Unibody is simple - it only requires removing one screw!
What you need
-
-
With the case closed, place the Unibody top-side down on a flat surface.
-
Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.
-
-
-
-
Remove the single Phillips screw securing the hard drive bracket to the upper case.
-
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.