Step 1: Battery
Steps 2–3: Memory Door
Steps 4–10: Upper Case
Steps 11–17: Display Assembly
Steps 18–22: Rear Display Bezel
Steps 23–32: LCD Panel
Steps 33–41: Front Display Bezel
Parts
MacBook Pro 15" (Model A1150) Front Display Bezel
$79.95 · 0 in stock
Tools
Spudger
$2.95 · 153 in stock
Phillips #00 Screwdriver
$4.95 · 991 in stock
T6 Torx Screwdriver
$4.95 · 380 in stock
Step 4
—
Upper Case
Remove the two Phillips screws in the battery compartment near the latch.
Step 5
Remove the following 6 screws:
Two 10 mm T6 Torx screws on either side of the RAM slot.
Four 14.5 mm Phillips screws along the hinge.
Step 6
Remove the four Phillips screws on the port side of the computer.
Be careful when reassembling your laptop -- do not put the screw into the DVI port! It will not come out.
To keep this from possibly happening, I placed 2 pieces of tape over the DVI connector pin holes.