Installing MacBook Pro 13" Unibody Mid 2009 Logic Board

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Add Note x

This guide is an internal private guide used as a prereq.

first image
thumb image 1
thumb image 2
thumb image 3

Add Note Edit Step 1 — Logic Board  ¶ 

  • Grab the plastic pull tab secured to the display data cable lock and rotate it toward the DC-in side of the computer.

  • Pull the display data cable connector straight away from its socket.

first image
thumb image 1
thumb image 2

Add Note Edit Step 2  ¶ 

  • Remove the following two screws securing the display data cable bracket to the upper case:

    • One 7 mm Phillips.

    • One 5 mm Phillips.

  • Lift the display data cable bracket out of the upper case.

first image

Add Note Edit Step 3  ¶ 

  • Use the flat end of a spudger to pry the subwoofer and right speaker connector up off the logic board.

Next » « Previous

Popular Device Products

9.5 mm SATA Optical Bay SATA Hard Drive Enclosure

$59.95 · 2 in stock

750 GB 7200 RPM Seagate SATA Hard Drive Upgrade Kit (New)

$219.95 · 22 in stock

MacBook Pro 13" Unibody Battery

$109.95 · 5 in stock

13" Unibody LCD Panel

$129.95 · 49 in stock

Arctic Silver Thermal Paste

$8.95 · 50+ in stock

Notes Add Note Notes are offturn on