Installing MacBook Pro 13" Unibody Display

Add Note Introduction

Use this guide to replace a broken display on your MacBook Pro 13" Unibody.

Parts relevant to this guide
In Progress

In Progress

This guide is currently being written. Reload periodically to see the latest changes.

Unpublished

Unpublished

This guide will not appear in search results but can still be viewed by anyone!

Paginated Single Page Steps

first image

Add Note Step 1 — Lower Case

  • Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

first image

Add Note Step 2

  • Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.

first image

Add Note Step 3 — Battery

  • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

Notes

There are no notes