first image

Add Note Step 40

  • Use a spudger to rotate the MagSafe board up and out of its housing. It may be helpful to pull the lower case out slightly to provide additional clearance.

first image

Add Note Step 41

  • Lift the left speaker out of its housing and set it to the side.

first image

Add Note Step 42

  • Remove the following 3 screws:

    • Two 7.5 mm Phillips from either end of the left I/O frame.

    • One 9 mm Phillips from the middle of the left I/O frame.

  • Remove the small black plastic spacer at the bottom of the left I/O frame.

Notes

There are no notes