Installing iPod Nano 4th Generation Display

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Add Note x
  • x 4

Use this guide to replace a broken display.

Sections
Tools
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Glass Panel  ¶ 

  • Insert the edge of an iPod opening tool into the gap between the outer case and the top bezel.

  • Pry the top bezel off the adhesive securing it to the display retainer.

  • At this point the hold switch slider is free and may fall. Be careful not to lose it.

first image

Add Note Edit Step 2  ¶ 

  • Remove the hold switch slider from the top of the Nano.

first image

Add Note Edit Step 3  ¶ 

  • Remove the two angled Phillips screws from the two corners of the display retainer.

  • These screw heads are extremely small and easily stripped.

Next » « Previous

Required Tools

Spudger

$2.95 · 50+ in stock

Phillips #00 Screwdriver

$4.95 · 50+ in stock

Tweezers

$2.95 · 50+ in stock

Plastic Opening Tools

$2.95 · 50+ in stock

Recommended Tools

Home Tech Toolkit

$24.95 · 50+ in stock

Sorting Tray

$7.95 · 50+ in stock

Anti-Static Wrist Strap

$7.95 · 14 in stock

Pro Tech Base Toolkit

$59.95 · 50+ in stock

Thirsty Bag

$6.95 · 50+ in stock

Popular Device Products

iPod Nano Gen 4 Color Display

$29.95 · 3 in stock

iPod Nano Gen 4 Glass

$19.95 · 25 in stock

iPod Nano Gen 4 Replacement Battery

$14.95 · 44 in stock

Notes Add Note Notes are offturn on