Installing iMac Intel 20" EMC 2266 RAM

  • Add Note x
  • x 5

Use this guide to replace or upgrade your RAM chips.

Sections
Tools
Relevant parts
first image

Add Note Edit Step 1 — Access Door  ¶ 

  • Lay your iMac front side down on a table with the lower edge facing yourself.

  • Loosen the single Phillips screw in the center of the access door.

  • This screw is captive in the access door.

  • Remove the access door from your iMac.

first image
thumb image 1
thumb image 2

Add Note Edit Step 2 — RAM  ¶ 

  • Use the sharp end of a spudger to pull the black plastic RAM tabs out of the memory bay.

  • Pull the black plastic RAM tab away from your iMac to eject the RAM chip.

first image

Add Note Edit Step 3  ¶ 

  • Grab the RAM chip by its edges and pull it straight out of its slot.

  • If two RAM chips are installed, repeat this process for the other chip.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the iMac Intel 20" EMC 2266 device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on