Step 1: Battery
Steps 2–5: Keyboard
Steps 6–17: Lower Case
Steps 18–19: Bottom Shield
Steps 20–23: DC-In Board
Steps 24–27: Upper Case
Steps 28–29: Top Shield
Steps 30–33: AirPort Extreme Card
Parts
iBook G4 12" 1.33 GHz or 14" 1.42 GHz Airport/Bluetooth...
$69.95 · 0 in stock
Tools
T8 Torx Screwdriver
$4.95 · 238 in stock
Phillips #00 Screwdriver
$4.95 · 998 in stock
Flathead 3/32" Screwdriver
$4.95 · 43 in stock
Spudger
$2.95 · 168 in stock
Installing iBook G4 14" 1.42 GHz AirPort Extreme Card
Introduction
| Difficulty: | Moderate |
|---|
Install an AirPort Extreme 802.11g card internally.
Tools used in this guide
Parts relevant to this guide
Paginated Single Page Steps
Step 1
—
Battery
Use a coin to rotate the battery locking screw 90 degrees clockwise.
Lift the battery out of the computer.
Step 2
—
Keyboard
Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.
If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (shown in orange) 180 degrees in either direction and try again.
Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.
Step 3
Remove the four silver Phillips screws that secure the RAM shield.
Notes
There are no notes