Step 1: Battery
Steps 2–4: Keyboard
Step 5: RAM
Steps 6–8: Lower Case
Step 9: Airport Card
Steps 10–13: Hard Drive
Steps 14–19: Optical Drive Removal
Steps 20–22: DC-In Board
Steps 23–27: Modem Filter Board
Parts
G4 Titanium DVI Modem Filter Board
$9.95 · 10 in stock
Tools
T8 Torx Screwdriver
$4.95 · 89 in stock
T6 Torx Screwdriver
$4.95 · 163 in stock
Installing PowerBook G4 Titanium DVI Modem Filter Board
Introduction
| Difficulty: | Moderate |
|---|
How to access the PowerBook G4 Ti DVI Modem Filter Board.
Tools used in this guide
Parts relevant to this guide
Paginated Single Page Steps
Step 1
—
Battery
Locate the battery release tab on the underside of the G4.
Slide the battery release tab to the left and lift the battery out of the computer.
Step 2
—
Keyboard
Turn the keyboard locking screw located in the middle of the keyboard so that it is parallel to the space bar.
Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
Step 3
Rest the keyboard face down on the trackpad area.
Disconnect the keyboard connector from the logic board.
The keyboard connector can be very tightly connected. Use caution and a pair of needle nose pliers to pull it up from the board. The left side of the connector (left as shown in the photo) is easier to grasp than the right, so grab it on that side with the pliers and pull carefully. It will come off.