Installing MacBook Unibody Model A1278 Hard Drive Cable

Add Note Introduction

This guide will show you how to remove the hard drive cable from your laptop.

Tools used in this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Access Door

  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

first image

Add Note Step 2

  • The access door should now be raised enough to lift it up and out of the Unibody.

first image

Add Note Step 3 — Battery

  • Be sure the access door release latch is vertical before proceeding.

  • Grab the white plastic tab and pull the battery up and out of the Unibody.

Notes

There are no notes