Installing MacBook Unibody Lower Case

Add Note Introduction

Replace the aluminum bottom case in a MacBook Unibody.

Tools used in this guide
Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Access Door

  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

first image

Add Note Step 2

  • The access door should now be raised enough to lift it up and out of the Unibody.

first image

Add Note Step 3 — Battery

  • Be sure the access door release latch is vertical before proceeding.

  • Grab the white plastic tab and pull the battery up and out of the Unibody.

Notes

There are no notes