Installing MacBook Pro 15" Unibody Late 2008 and Early 2009 Lower Case

  • Add Note x
  • x 6

Replace the aluminum bottom case in a MacBook Pro Unibody.

Sections
Tools
Relevant parts
first image
thumb image 1
thumb image 2

Add Note Edit Step 1 — Access Door  ¶ 

  • With the case closed, place the Unibody top-side down on a flat surface.

  • Depress the grooved side of the access door release latch enough to grab the free end. Lift the release latch until it is vertical.

first image

Add Note Edit Step 2  ¶ 

  • The access door should now be raised enough to lift it up and out of the Unibody.

first image

Add Note Edit Step 3 — Battery  ¶ 

  • Be sure the access door release latch is vertical before proceeding.

  • Grab the translucent plastic tab and pull the battery up and out of the Unibody.

  • If the latch is depressed it will lock the battery in place.

first image

Add Note Edit Step 4 — Lower Case  ¶ 

  • Remove the following eight screws securing the lower case to the chassis:

    • One 5.4 mm Phillips screw.

    • Three 14 mm Phillips screws.

    • Four 3.5 mm Phillips screws.

first image

Add Note Edit Step 5  ¶ 

  • Using both hands, lift and remove the lower case off the upper case.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the MacBook Pro 15" Unibody Late 2008 and Early 2009 device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on