Installing MacBook Pro 13" Unibody Mid 2009 Hard Drive

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Add Note x

This guide is an internal private guide used as a prereq.

first image

Add Note Edit Step 1 — Hard Drive  ¶ 

  • Remove two Phillips screws securing the hard drive bracket to the upper case.

  • These screws are captive to the hard drive bracket.

first image

Add Note Edit Step 2  ¶ 

  • Lift the the retaining bracket out of the upper case.

first image

Add Note Edit Step 3  ¶ 

  • Lift the hard drive by its pull tab and pull it out of the chassis, minding the cable attaching it to the computer.

first image

Add Note Edit Step 4  ¶ 

  • Remove the hard drive cable by pulling its connector straight away from the hard drive.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the MacBook Pro 13" Unibody Mid 2009 device page.

Did you successfully follow this guide?

Notes Add Note Notes are offturn on