Installing MacBook Air Processor Clamp

Add Note Introduction

The processor clamp helps keep the heat sink close to the processors.

Tools used in this guide
Parts relevant to this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Lower Case

  • Remove the following 10 screws securing the lower case to the Air:

    • Six 2.8 mm Phillips screws.

    • Two 3.8 mm Phillips screws.

    • Two 5.4 mm Phillips screws.

first image
thumb image 1
thumb image 2

Add Note Step 2

  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

first image

Add Note Step 3 — Battery

  • Disconnect the battery connector by pulling it straight away from its socket.

Notes

There are no notes