Installing MacBook Air DC-In Board

Add Note Introduction

Your Air is thirsty! Keep those electrons flowing and fix your broken DC-In board.

Tools used in this guide

Paginated Single Page Steps

first image

Add Note Step 1 — Lower Case

  • Remove the following 10 screws securing the lower case to the Air:

    • Six 2.8 mm Phillips screws.

    • Two 3.8 mm Phillips screws.

    • Two 5.4 mm Phillips screws.

first image
thumb image 1
thumb image 2

Add Note Step 2

  • Slightly lift the lower case near the vents and push it toward the rear of the computer to free the mounting tabs.

first image

Add Note Step 3 — Battery

  • Disconnect the battery connector by pulling it straight away from its socket.

Notes

There are no notes