Removing Delphi MyFi XM2GO Battery
Better coordination with markups and the color/type of bullets will help make this guide more clear!
Some of this guide's text is confusing, duplicated, or off-topic. Clarify it by editing!
An awesome member of our community made this guide. It is not managed by iFixit staff.
This guide demonstrates removing the user-removable Lithium Ion battery.
- Author: Scott Byer
- Time required: 1 Minute
- Difficulty: Very easy
Embed this guide
With the HTML code below, you can embed this guide as a small widget on your website.
Locate the large button on the top back of the device. This button is used to release the latch holding the sliding back cover in place.
Press this button at the top while making a firm grip on the battery cover.
As the button is pressed, move the cover towards the bottom of the device while applying moderate pressure to the cover.
Be careful to not press down too hard on the battery cover as it is made of plastic.
The battery removal tab may pop up during the cover removal process.
Removing the back cover allows access to the user-removable battery.
Should the battery need to be replaced or swapped, following these steps will aid in the process.
The battery comes from the manufacturer with a pull tab with a web address printed on it to direct the user in purchasing a new battery.
Holding the device, grab the tab with thumb and index figure.
Pull down on the tab so that the battery block moves a few millimeters towards the bottom of the device.
The battery will move parallel to the back of the device while a latch at the top is freed with the downward motion.
There is a pivot point at the bottom of the battery where the contacts connect to the battery.
After the latch at the top is disengaged, pivot the battery away from the back and the battery will be free.
Comments Comments are onturn off