first image

Add Note Edit Step 16 — Hard Drive Replacement  ¶ 

  • Remove the four black Torx screws located at the four corners of the hard drive bracket.

first image

Add Note Edit Step 17  ¶ 

  • Pull the connector cable out from the hard drive, applying even pressure while gently rocking up and down.

  • Be very careful to apply even pressure when removing the cable. If you torque too hard to either side, you may damage or destroy the hard drive's connector pins, rendering your data inaccessible.

Next » « Previous

To reassemble your device, follow these instructions in reverse order.

For more information, check out the PowerBook G3 Lombard device page.

Did you successfully follow this guide?

This guide has been completed 3 times.

Comments Add Note Comments are offturn on