← prev | next →

Page 6 of 8

first image

Step 16

  • Remove the single black T6 Torx screw securing the clear plastic shield over the right ambient light sensor.

  • Lift the clear plastic shield off the right ambient light sensor.


first image

Step 17

  • Peel up the orange Kapton tape securing the right thermal sensor cable to the logic board.


first image

Step 18

  • Remove the following ten screws:

    • Seven 6.5 mm T6 Torx screws.

    • Two 7.6 mm T6 Torx screws securing the battery connector to the lower case.

    • Three 7.8 mm T6 Torx screws.


← prev | next →

Page 6 of 8