Installing iPod Touch 3rd Generation Power/Volume Controls

Prerequisite Only

Prerequisite Only

This guide is only used as a prerequisite for other guides and is not a complete or useful guide when viewed independently.

  • Add Note x
first image

Add Note Edit Step 1 — Power/Volume Controls  ¶ 

  • Remove the two Phillips screws securing the power/volume controls to the rear panel.

first image

Add Note Edit Step 2  ¶ 

  • Use the tip of a spudger to remove the yellow kapton tape covering the power/volume control ribbon cable.

first image

Add Note Edit Step 3  ¶ 

  • Remove the two Phillips screws securing the power/volume controls to the rear panel.

  • Lift the power/volume controls out of the rear panel.

To reassemble your device, follow these instructions in reverse order.

For more information, check out the iPod Touch 3rd Generation device page.

Did you successfully follow this guide?

This guide has been completed 0 times.

Comments Add Note Comments are offturn on